Hind Vactech Scientific Pvt.Ltd.

+91 99588 22058 & +91 97160 14312

Our Product Range

Vactech Vacuum Pumps

Laboratory Cooling Equipments

Laboratory Heating Equipment

Laboratory Testing Equipment

Vacuum Gauges

Lubricating Oils

Fittings & Flanges

Digital pirani vacuum gauge

The UVS Model DPRG series Vacuum Pirani Gauge Controller displays vacuum pressure as measured from a S-PR-GH sensor tube. It displays vacuum measurements based on thermal conductivity of air or nitrogen. The Model DPRG-XGH-SP controller covers the range from 0.001bar to 1000 mbar, and controls relay with independent set point.
***The optional RS232 along with analog output 0 to 10V and 4 to 20 mA facility can be obtained on request

Applications

  • Controlling high vacuum systems
  • Fore vacuum pressure monitoring
  • Safety circuits in vacuum systems
  • General vacuum measurement & control in the fine and rough vacuum range.
  • Measurement range 0.001 to 1000 mbar
  • Easy "ATM" and "0" adjustment on the signal conditioner PCB
  • Space saving rugged design- 1/8 DIN console
  • Mounts in any orientation
  • Brass body measuring cell with metal-sealed feed through
  • With universal power supply – input voltage from 90 ~ 264VAC, frequency 47 ~ 440Hz
  • Integrated set point adjustment and relay output
  • Easy To Read 4 Digit Backlit Display
  • Dual Set Point Controller With 2 Relays (select model DPRG-2GH-SP)
  • Change Cable Length Without Re-calibrating upt o 8 mtrs
  • Technical specifications:

    MODLES
    DPRG-1GH
    DPRG-1GH-SP
    DPRG-2GH
    DPRG-2GH-SP
    DPRG-1GH-2SP
    Number of sensor channels
    ONE
    TWO
    ONE
    Display Range
    FULL range: 0.001 to 1000 mbar
    Measuring Range
    USEFUL range :0.001mbar to 100 mbar
    Units of Display
    m Bar
    Vacuum Gauge
    S-PR-GH sensor tube
    Temp. Range
    2 to +50 deg. Celsius
    VAC. Display
    4-digit bright red LED, 14 mm high
    Display Indicators
    NIL
    Red LED for SET PT 1
    Red LED for channel 1&2 selected
    Red LED for channel 1&2
    Selected& red LED for SET PT 1&2
    RED LED for set point 1 & 2
    VAC and ATM Adjust
    adjusted by trim pot at the signal conditioner PCB.
     
    Process control set points
    NIL
    ONE
    NIL
    TWO
    TWO
    Process Control Relays
    NIL
    One relay, 2 amp, 240 VAC contacts; independent available through the DB15 accessory connector
    NIL
    Two relays, 2 amp, 240 VAC contacts; independentavailable through the DB15 accessory connector
    Two relays, 2 amp, 240 VAC contacts; independent available through the DB15 accessory connector
    Nonvolatile Memory
    for SET POINTS
    Operating Voltage
    universal power supply,which operates on input voltages from 90 ~ 264VAC 50/60 Hz; standard IEC 320 instrument power input receptacle on rear panel; replacement fuse type:
    5 mm X 20 mm, 2 amp
    Mounting
    Side clips are provided for panel mounting in standard
    ¼ DIN 92 x 92 mm (3.62" x 3.62")
    Environmental Considerations
    not for use with explosive or corrosive gases